Motorola STB3508 Quick Reference Manual page 6

6
Mounting the Cradle
Horizontal Mount
Ensure the desk/wall mount
1.
converter knob is in the correct
position, shown at right.
If mounting the cradle horizontally
2.
where no fastening is necessary,
peel the protective paper from the
back of the rubber feet included
with the cradle packaging, and
attach the feet to the cradle at the
indentations in the plastic. These feet provide traction and prevent surface
damage.
Vertical Mount
Do not use the rubber feet when mounting in a vertical orientation.
NOTE
To mount the cradle on a vertical surface:
Use a Philips screwdriver to turn the desk/wall mount converter knob to the
1.
position shown below. The front latches protract to engage the depressions at
the base of the scanner's handle.
Attach the interface and power cables to the appropriate ports (see
2.
Connections).
Press the cables into the cable grooves.
3.
Position the cradle on the mounting surface, or use the template included in
4.
this guide.
Mark the surface through the three holes on the bottom of the cradle, or use
5.
the mounting template to determine the location of the screw holes.
Pre-drill holes to accommodate three 1,5" #8 Philips head screws.
6.
Attach the cradle securely to the surface.
7.
Place the scanner in the cradle.
8.
Converter Knob:
Horizontal Position
Converter Knob
Vertical Position
STB3508/3578 Cradle
Cradle