Cradle Connections - Motorola STB3508 Quick Reference Manual

Quick Reference Guide

Cradle Connections

IMPORTANT
Insert the interface cable into the cradle's
1.
host port.
Connect the other end of the interface
2.
cable to the host.
If necessary, connect the power supply to
3.
the cradle's power port (if required by the
interface, or to allow fast charging of the
scanner).
Connect the appropriate cable to the
4.
power supply and an AC power source,
if necessary.
If applicable, thread the interface cable
5.
over the cable support hook and run the
host and power cables into their
respective cable grooves.
If necessary, scan the appropriate host
6.
bar code (for non-autodetected
interfaces). Refer to the Product
Reference Guide.
Changing the Host Interface
To connect to a different host, or to the same
host through a different cable:
Unplug the power supply from the cradle.
1.
Unplug the interface cable from the host.
2.
Connect the interface cable to the new host, or the new interface cable to the
3.
existing host.
Reconnect the power supply, if required.
4.
If necessary, scan the appropriate host bar code (for non-autodetected
5.
interfaces). Refer to the Product Reference Guide.
CAUTION
Connect the interface cable and power supply (if necessary)
in the following order to ensure proper operation of the
scanner and cradle.
If the scanner does not recognize the host, disconnect the
power supply, then reconnect after connecting the host
cable.
Host
Port
5
Power Port