Chapter One; Installing Dialer; Adding Names & Numbers - Able-phone AP-5000 User Manual

4
• Chapter Three answers Frequently Asked Questions, and
provides technical details, important notices, and warranty
information.

Chapter One

This chapter describes how to install Dialer, add names, erase a name or all
names, listen to stored names, and, most importantly, dial a name using only
your voice!

Installing Dialer

To use Dialer, install it by following these three steps:
A. Connect the supplied power adaptor to the AC wall outlet and to the Dialer
jack marked 'Power'. When the power is applied, you should see two
bright blue lights light up, one on the 'phone' jack and the other on the 'line'
jack of the Dialer unit. They indicate that the power is ON. If you do not
see these lights, please see the 'Frequently Asked Questions' section in
Chapter Three for assistance.
B. Connect the modular cord from your telephone to the Dialer jack marked
'Phone'.
C. Connect the supplied modular cord from the Dialer jack marked 'Line' to
the modular phone jack on your wall.
That's It! Dialer is now ready to be used.
Adding names & numbers
Once Dialer is connected, you can start adding names. Please follow these
steps:
A. Make a list of the names and numbers you wish to add to Dialer. This
list is important because it will simplify training Dialer. Consider these
tips:
• Do not use very short names like 'Joe'. Instead, use both
first and last names.
• If two names are very similar (first name, or last names,
are the same in both names), try training one of the
names in reverse order.
[Type text]