Table of Contents
Advertisement
MAINTENANCE
SCRUB BRUSHES
4.
There are four different types of brushes available
to cover applications from cleaning heavily soiled
floors to polishing. A pad driver is also available to
take advantage of the many cleaning pads on the
market. Please refer to the following to assist in
selecting the proper brush or pad for the work at
hand.
UNCOATED FLOORS
Aggressive Grit is a nylon fiber impregnated with
silicone carbide grit. It grinds away stain, soil, and
removes surface material.
Mild Grit is a less aggressive silicone carbide grit
suitable for cleaning medium soil conditions.
Advantages are faster ground speed than nylon
bristles on light solid applications.
Polypropylene is a general-purpose scrub brush
with stiff bristles. Polypropylene works well for
maintaining concrete, wood and tile floors.
FINISHED FLOORS
Nylon bristles are used in a variety of applications
on coated or uncoated surfaces.
White Pads (Polishing) are used for dry polishing
to achieve a high-gloss appearance, or surface
washing on highly polished or burnished floors.
Red Pads (Buffing) are used for light-duty
scrubbing. When used with a mild detergent they
will provide surface cleaning without removing the
finish.
Blue Pads (Scrubbing) are used for heavy-duty
scrubbing and light stripping. The blue pads
remove less finish than brown stripping pads, yet
will remove black marks, stains and dirt.
Black Pads (Stripping) are used for easy and
complete removal of old floor waxes/finishes. They
will quickly remove ground in dirt, black heel
marks, and spills. When used with the proper
stripper, this pad leaves the floor clean and ready
for finishing.
The scrub brushes should be checked before each
days work for wire, string, wear and damage .
4-8
CUTTER 36V (SCEX) 86037040 12/12/06
REPLACING OR INSTALLING SCRUB
BRUSHES
1. With the scrub deck up, turn "OFF" the
machine.
FOR SAFETY: Before leaving or servicing the
machine; stop on level surface, turn OFF
machine and remove key.
2. Remove the brush cover shrouds.
3. Locate release lever on top of brush or pad
driver. Rotate release lever counter-clockwise
and the brush/pad driver will release and drop
down.
4. To reinstall, center the brush driver under the
brush drive hub. Raise until it contacts brush
driver assembly. Turn clockwise until release
lever plate locks into position.
5. Replace the brush cover shrouds.
NOTE: Check that release plate is completely
closed and pad/brush is securely attached.
Damage to driver or brush could occur.
5. RECOVERY TANK FLOAT SHUT-OFF
When water is no longer being vacuumed from
the floor and the vacuum fan is operating, the
ball float has engaged. The vacuum motor will
not vacuum water with recovery tank full. The
recovery tank must be drained.
1. The float shut-off screen can be cleaned in or
out of the machine.
2. To clean the float shut-off while it is inside the
machine wipe material off screen then rinse.
Check that the ball is also clean and moves
freely.
3. To remove the float shut-off, grasp the screen
with one hand and the connected tube with the
other. Tilt and pull the float screen assembly to
pull it off the barb on the tube.
4. To install, place one hand on the tube, and
then tilt and push the float screen assembly
over the barb on the tube.
Advertisement
Table of Contents
