Blade Tilt Stops - Grizzly G1023RLX Owner's Manual

Blade Tilt Stops

The table saw features stop bolts that stop the
blade exactly at 45° and 90° during blade tilt
adjustments. The stops have been set at the fac-
tory and should require no adjustments, unless
you notice that your cuts are not accurate.
Note: The tilt scale reads "0" when the blade is
90° to the table.
Tools Needed
90° Square ........................................................ 1
Combo Square .................................................. 1
Wrench 12mm ................................................... 1
Hex Wrench 3mm .............................................. 1
Setting 90° Stop Bolt
1. DISCONNECT SAW FROM POWER!
2.
Raise the blade as high as it will go, then tilt
it toward 0° until it stops and cannot be tilted
any more.
3.
Place a 90° square against the table and
blade so it contacts the blade evenly from
bottom to top, as shown in Figure 97. Make
sure a blade tooth does not obstruct the
placement of the square.
Blade
Table
Figure 97. Checking blade at 90°.
Model G1023RL Series (Mfd. Since 12/11)
Qty
90° Square
—If the blade is 90° to the table, then adjust-
ments do not need to be made. Make sure
the tilt indicator arrow shown in Figure 98
points to the 0° mark on the scale. If it does
not, remove the blade height lock knob,
loosen the blade height handwheel set
screw and remove the handwheel.
Figure 98. Tilt indicator arrow.
Adjust the indicator position by loosening
the Phillips head screw, moving the indica-
tor, then tightening the screw and reinstall-
ing the handwheel. Proceed to Setting 45º
Stop Bolt on Page 60.
—If the blade is not 90° to the table, you will
need to adjust the 90° stop screw. Proceed
to the next step.
4. Tilt the blade to about 20°, so there is room
for the stop bolt to move.
Indicator
Phillips Head
Screw
-59-