Grizzly G1023RLX Owner's Manual page 23

11. Mount the switch brace, as shown in Figure
17, using the pre-installed table mounting fas-
teners on the top end and the switch mount-
ing fasteners on the bottom end.
Figure 17. Switch bracket installed.
12. Attach the latch to the motor cover with (2)
#8-32 x ⁄ " Phillips head screws and (2)
3
8
#8-32 hex nuts, as shown in Figure 18.
x 2
Figure 18. Latch installed.
13. Place the motor cover on the cabinet, line up
the hinges, and tap the hinge pins into place
with a hammer, as shown in Figure 19.
Figure 19. Motor cover installed.
Model G1023RL Series (Mfd. Since 12/11)
Fasteners
14. Mount the fence resting brackets with (4)
M5-.8 x 8 button head cap screws, as shown
in Figure 20.
x 4
Figure 20. Fence resting brackets installed.
15. Mount the dust port onto the cabinet with
the (4) pre-installed tap screws, as shown in
Figure 21.
Figure 21. Dust port installed.
16. Thread the handwheel handle into the
handwheel and tighten it (see Figure 22).
Figure 22. Handle installed on handwheel.
x 4
Handle
-21-