Setting The Time; Loading A Dvd Map Disc - Hummer H3 2006 Manual

Hide thumbs Also See for H3 2006:
Table of Contents

Advertisement

Setting the Time

To set the time, do the following:
1. Press the power/volume knob to turn the system on.
2. Press the CONFIG hard key.
3. Touch the Clock screen button.
4. Scroll through the Time Zones until the desired time
zone is highlighted.
5. Touch the Daylight Savings screen button.
The time is now set. Touch the Manual Adjust screen
button if you need to further adjust the time. The
radio will use the GPS satellite to set the time. The
vehicle needs to be in an open area to receive
the signal. See Global Positioning System (GPS) on
page 2-36 for more information.

Loading a DVD Map Disc

To load a DVD map disc, do the following:
1. Press the power/volume knob to turn the system on.
2. Press and hold the eject key to tilt the screen
forward.
3. Insert the DVD map disc into the DVD slot.
Notice: Pressing directly on the navigation screen
may cause damages. Repairs would not be
covered by your warranty. Do not press directly on
the navigation screen.
4. To close the screen, slightly push up on the
two outer top corners until the screen is in position,
then push the screen in, by pushing on the
four outer corners, until you hear a click.
5. A notice may appear. Touch the NEXT screen
button to proceed.
Entering an Address, Point of Interest,
Home, and Preset Destinations
Before entering an Address, Point of Interest, Home, or
Preset Destination, select the appropriate search
area that contains the final destination. Your vehicle
must be in PARK (P) to perform this operation.
1-5

Advertisement

Table of Contents
loading

Table of Contents