Setting Preset Stations - Hummer H3 2006 Manual

w x
SEEK : Press the SEEK up or the down arrow to
go to the next or previous station and stay there.
To scan stations, press and hold the SEEK up or down
arrow for two seconds until you hear a beep. The
radio will go to a station, play for a few seconds, then
go on to the next station. Press either SEEK arrow again
to stop scanning.
To scan preset stations, press and hold the SEEK up or
down arrow for more than four seconds. You will hear
two beeps and PSCAN will appear on the display, along
with the highlighted preset. The radio will go to the
next preset station, play for a few seconds, then go on
to the next preset station. Press either SEEK arrow
again to stop scanning presets.
The radio will only seek and scan stations with a strong
signal that are in the selected band.

Setting Preset Stations

Up to 30 stations, six AM, six FM1, six FM2, six XM1,
and six XM2, if equipped, can be programmed using the
six screen buttons on the bottom of each band menu.
To set preset stations, do the following:
1. Turn the audio system on.
2. Press the BAND hard key to select AM, FM1, FM2,
XM1, or XM2, if equipped.
3. Tune in the desired station using the SEEK hard
key or the tuning knob.
4. Press and hold one of the six preset screen buttons
until you hear a beep. Whenever that screen button
is pressed, the station that was set will return.
5. Repeat the steps for each preset and source.
3-3