Traction Pedal; Parking Brake - Jacobsen AR-522 Safety And Operation Manual

4 CONTROLS
A. Tilt Steering Lever
Pull lever up to release steering column. Tilt
column up or down to position desired.
Release lever to lock steering column in
place.
!
CAUTION
Never adjust steering while mower is moving. Stop
unit and set parking brake before adjusting.
B. Parking Brake Lock/Release
To lock parking brake, hold brake pedal (C) down and
press lock (B ) until it engages. To disengage, press
1
brake pedal release (B
NOTICE
The engine will automatically shut down if the traction
pedal is held down for more than 10 seconds with the
parking brake engaged.
C
C. Parking Brake
To engage parking brake press pedal down.
D. Mow Speed Stop
Limits forward speed while mowing. To operate at lower
travel speed while mowing, rotate lever so it contacts
stop screw (D ) on floor board when forward travel
1
pedal is pressed. To travel at full speed, set lever in
position shown (D ). Stop screw (D
3
set specific mow speeds. See Parts & Maintenance
Manual.
E. Traction Pedal - Forward
Press front of pedal down for forward travel. Release
pedal to slow mower and stop.
F. Traction Pedal - Reverse
Press rear of pedal down for reverse travel. Release
pedal to slow mower and stop. Allow mower to come to
a complete stop before reversing directions.
12
).
2
B
1
B
2
Figure 4A
) can be adjusted to
2
D
3
Transport Speed
G. Seat Adjustment
Pull left side lever out to adjust seat forward or
backward. To adjust spring tension under seat turn
adjusting knob on front of seat.
H. Hydraulic Oil Cap / Dipstick
Fill to mark on dipstick using clean hydraulic fluid while
machine is cool. Do not overfill.
J. Air Cleaner Indicator
Indicates condition of air cleaner on engine. Clean or
replace air filter when red band appears in clear window
of indicator. See Parts & Maintenance Manual.
K. Fuel Cap
Fill fuel tank with No. 2 diesel fuel, minimum Cetane
Rating of 45. See Section 5.11.
L. Alarm
The alarm, along with the warning lights (N, Y), sounds
to alert the operator to conditions requiring immediate
attention. See Section 4.4.
M. Controller / Fuses
The controller is located under the rear hood directly
behind the operator's seat. It is equipped with LEDs to
aid in monitoring and troubleshooting the electrical
system of the mower. See Parts & Maintenance
Manual.
Two spade type fuses are located on the controller. To
replace fuses remove the access panel.
!
CAUTION
Service to the electrical system must be performed by a
trained technician. Before replacing fuses turn mower off
and remove key from ignition.
D
LF002
1
D
2
E
F
Mow Speed
Figure 4B