Midi Input Configuration - Wave Idea Bitstream PRO Owner's Manual

MIDI Input Configuration

The following table illustrates the SYSEX that must be sent to BitStream in order to configure its MIDI
input.
MIDI in is used to configure BitStream by SYSEXs, it is also used to chain a MIDI setup where other
messages are destined to other Soft / Gears.
MIDI messages incoming from MIDI in are merged with MIDI messages internally generated by
BitStream, and retransmitted to the BitStream MIDI output.
BitStream can be configured in order to merge and retransmit ALL incoming MIDI data (Default
configuration), or can be configured in order to filter several MIDI messages such as real-time
messages (MIDI clock, start, stop, continue). It is also possible to filter all incoming MIDI data; in this
case, MIDI output provides only MIDI data generated by BitStream.
These different options of merging / filtering can be configured by the following SYSEX:
Byte (Hexadecimal)
F0
00
20
4F
00
00
5N
F7
MIDI Thru : ON
Filter : OFF
N = 0 : All incoming MIDI data are retransmitted
N = 1 : Real-time MIDI data are filtered
N = 8 : All incoming MIDI data are filtered
MIDI Input Configuration
(Message recognized by BitStream Pro)
MIDI Thru : ON
Filter : ON
Rev 3.1 - Page
Description
Start of SYSEX
Waveidea ID
MIDI Controller ID
BitStream Pro ID
BitStream Pro ID
Reserved
End of SYSEX
MIDI Thru : OFF
Filter : OFF
24