Installation And Use; Power Connection - Vicsign HWQ series User Manual

http://www.vicsign.com
Take out every party of the stand from the packing box, turn on the party bag, and install the stand according to
the illustrational showing. Lay the cutter on the stand after install, aim at and install spiral shell, then lock with the
screw.
b Installation and Use
1 Place the cutter in a plane and roomy place, and make sure there is 300mm room place around the cutter.
2 Notes on Location (Do not locate the plotter in any of the places listed below)
— A place exposed to direct sunlight
— A place that vibrates
— A dusty place
— A place where temperature or humidity varies significantly
c Power connection
Check the electrical connection and power supply voltage before you connect plotter's power.
User manual of HWQ series vinyl cutter
8 / 29