Automatic Cruise Edge (Optional) - Vicsign HWQ series User Manual

http://www.vicsign.com
b

Automatic cruise edge (optional)

1. Open Flexi Software, import the graphic, click the blank part of image, the software will auto switch to
"design center" dialog, setting the cutting material size, for example, if you need cut in A4 size material, set the
size to "A4" as the picture show as below.
2. Support format of shaped outer contour cutting are: PSD、PNG
3. Select the image, then click the "effect" in menu, click "contour cut", set the proper contour line from outer
to image, depend on your demands, click "ok" to confirm. As the picture show, contour line can adjust depend
.
on your demands
Click this item
User manual of HWQ series vinyl cutter
25 / 29
In this place, the size setting
should be the same as printing
material size