Drawing Pen Installation - Vicsign HWQ series User Manual

http://www.vicsign.com
Set the
media,lift the
handle,which
controls the
pinch roller.
h. Knife set and adjusting
CAUTION
a. Install the knife into the holder. Rotate the knife sheath to adjust the length of exposed part of knife tip. Blade
holder exploded as shown below, the detail operation are described as followed:
b. For different material, users can adjust the length of knife sheath exposed at any time.
c. Install the blade holder into carriage
— Loosen the screw of tool carrier
— Assemble the blade holder into the tool carrier
— When the tool is in appropriate position, tighten the screw.
i. Drawing pen installation
The installation method for pen group is basically the same as blade holder, except for
User manual of HWQ series vinyl cutter
adjusting the nib.
16 / 29
Don't touch the knife top
with your finger prevent
injury.