Hyundai HYT140 User Manual page 12

4.6.1. The handle will engage the pinch roller against the drive belt, pulling it tight on the drive
shaft. The clutch needs to be set correctly so that the drive is removed from the revolving
blades once the dead-man's handle is released.
4.6.2. Drive should only be applied to the rotating blades when the clutch/dead-man's handle is
fully depressed. The adjustment is achieved by means of the inline screw adjuster on the
clutch cable.
4.7. Starting machine.
4.7.1. Preparation before starting.
4.7.1.1. Before starting the engine, check that all components are in correct position and
secured correctly.
4.7.1.2. Check the oil level as in Oil warning page 3.
4.7.1.2.1.
4.7.1.3. Check the machine has fuel, use fresh unleaded petrol.
4.7.2. Starting the engine.
4.7.2.1. When starting from cold, move the choke lever to the forward position.
4.7.2.2. Push the primer bulb 5 times.
4.7.2.3. When starting warm engine, turn throttle choke lever to the halfway position, then
starts as in 4.7.2.4. below if machine does not start then push the primer bulb in once fully.
Oil type - SAE 15W-40 lubricating oil for petrol engines.
Page 12