Operating Procedures - Hyundai HYT140 User Manual

3.4.3. Attach the depth bar (1) onto its support bracket (2)
and fix in place with the supplied 'B' Clip (4).
3.4.4. Adjust the wheel assembly (3) so that it helps to
support the machine when moving tiller. N.B. Only
adjust wheel when rotating blades are stopped. Wheel
should be raised when tilling.

4. OPERATING PROCEDURES

4.1. Filling with oil.
4.1.1. The machine is supplied with no oil.
4.1.2. Undo and remove filler cap and dipstick (2.1 item 14).
4.1.3. Carefully fill with oil approximately 550 ml, taking care not to spill. Clean up all oil fuel spills
before use.
4.1.4. Replace filler cap and tighten.
4.2. Filling with fuel.
4.2.1. The machine is supplied with no fuel before starting fill with fresh unleaded petrol.
4.2.2. Pour in fuel (approx. 1 litre). Avoid spillages and clean up all spills straight away.
4.2.3. Check seal inside the petrol cap for damage and replace if needed.
4.2.4. Replace cap and screw on firmly by hand.
4.3. Adjusting the wheel.
4.3.1. Adjust the wheel by pulling the support bracket of the wheel outwards against spring
tension, and fix it in the position as shown in below.
Always stop the engine before adding fuel, water or making any adjustments to
the machine.
Never put feet or hands near the tiller blade especially when machine is
running.
Before tilling, remove all foreign objects from the work area, which may cause
injury or damage.
Always keep children, people and pets at a safe distance when the tiller is in
use.
Always wear correct PPE when using this machine.
Recommended PPE but not limited too.
Page 10