Sony DAV-IS10 Operating Instructions Manual page 15

3
Connect the cords to the AM antenna (aerial) terminals.
The cords can be connected to either terminal.
Insert the cords pushing down the terminal clamp.
Note
• Do not place the AM loop antenna (aerial) near the system or other AV equipment, as noise may result.
Tip
• Adjust the direction of the AM loop antenna (aerial) for best AM broadcast sound.
4
Make sure the AM loop antenna (aerial) is connected firmly by pulling softly.
To connect the FM wire antenna (aerial)
Connect the FM wire antenna (aerial) to the FM 75 Ω COAXIAL jack.
Note
• Be sure to fully extend the FM wire antenna (aerial).
• After connecting the FM wire antenna (aerial), keep it as horizontal as possible.
Tip
• If you have poor FM reception, use a 75-ohm coaxial cable (not supplied) to connect the control unit to an outdoor
FM antenna (aerial) as shown below.
Insert until this
part.
FM wire antenna (aerial)
(supplied)
FM 75 Ω COAXIAL jack
Rear of the control unit
Outdoor FM antenna (aerial)
continued
15
GB