Sony DAV-IS10 Operating Instructions Manual page 84

1
Connect the calibration mic to the
ECM-AC2 jack on the rear of the control
unit, and set it up at the ear level using
a tripod, etc. (not supplied).
The front of each speaker should face the
calibration mic, and there should be no
obstruction between the speakers and the
calibration mic.
Note
• The ECM-AC2 jack is used for the supplied
calibration mic only. Do not connect other
microphones.
Rear of the control unit
2
Press FUNCTION repeatedly until
"DVD" appears in the front panel
display.
3
Press
in stop mode.
The Control Menu display appears on the
TV screen.
84
GB
To ECM-AC2 jack
Calibration mic
DISPLAY when the system is
4
Press X/x to select
CALIBRATION], then press
1 ( 4 4 )
3 ( 2 8 )
T 0 : 0 3 : 0 4
AUTO CALIBRATION
START
5
Press .
The [AUTO CALIBRATION] display
appears.
AUTO CALIBRATION
Connect calibration mic. Start
measurement?
YES
NO
6
Press X/x to select [YES], then press
to start [AUTO CALIBRATION].
Be quiet during the measurement.
Measuring. Please wait a moment.
Note
• Avoid being in the measurement area and
making noise during the measurement (about 1
minute), to avoid measurement failure. During
the measurement, test signals are output from
the speakers.
• The environment of the room in which the
system is installed may affect measurements.
[AUTO
.
DVD VIDEO