Assembly And Basic Adjustments - Omnitronic DD-5220L User Manual

21 Analog audio output (stereo RCA)
For connection to a line input or phono input, e.g. of an
amplifier or mixer.
22 Selector switch PHONO/LINE
Switches the audio level of the analog audio output
• [PHONO] for connection to a phono input
• [LINE] for connection to a line input
5. ASSEMBLY AND BASIC
ADJUSTMENTS
The headshell, the turntable platter and the
counterweight for the tone arm are separately
packed to prevent damage to the turntable during
transportation. After unpacking, the parts can be
easily assembled. The packing material should be
kept for transportation purposes.
Mounting the turntable platter
Fig. 1: Platter
1
Set up the turntable on a plane, stable
ground and place the turntable platter on the
axle of the turntable.
2
Place the supplied slipmat on the turntable
platter.
23 AC connection
Plug in the supplied power cable here.
24 Power on/off
Mounting the headshell
1
Refer to the manufacturer's instructions of
your cartridge
protective cap on the stylus.
Fig. 2: Cartridge system
2
Take the headshell out of one of the two
lateral polystyrene wrappings and screw your
phono cartridge system on the support. Only
tighten the screws on the loosely so that you
can still move the system. Put on the wires
as follows:
Color
white
blue
red
green
20/27
system and place
Channel, Pole
left channel positive pole
left channel negative pole
right channel positive pole
right channel negative pole
00063727.DOC, Version 1.0
the