Replacing The Drive Belts; Replacing The Headlight Bulb - Toro power max 926 Operator's Manual

Figure 52
2. Loosen the bolt on the cable clamp (Figure 53).
Figure 53
1. Cable conduit
3. Grasp the cable conduit and move it toward the front
of the machine until the discharge chute latch fully
engages the gear teeth (Figure 53 and Figure 54).
Figure 54
1. Discharge chute latch
Note: The latch is spring loaded and will naturally
move into the teeth of the gear (Figure 54).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp, being careful not
to strip the plastic part.
6. Install and secure the gear cover.
2. Cable clamp
2. Gear teeth

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, have an
Authorized Service Dealer replace the belt.

Replacing the Headlight Bulb

Use a GE 899 37W halogen light bulb. Do not touch the
bulb with your hands or allow dirt or moisture to come into
contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 55).
2. Turn the base of the bulb counterclockwise until it
stops (Figure 56).
3. Remove the bulb straight out from the back of the
headlight (Figure 57).
4. Insert a new bulb into the back of the headlight
(Figure 58).
25
Figure 55
Figure 56
Figure 57