Smart Settings - Asus P10S-M WS Series Instruction Manual

APM
Allows you to configure the Advance Power Management (APM) settings.
Restore AC Power Loss [Last State]
When set to [Power Off], the system goes into off state after an AC power loss. When set
to [Power On], the system will reboot after an AC power loss. When set to [Last State], the
system goes into either off or on state, whatever the system state was before the AC power
loss.
Configuration options: [Power Off] [Power On] [Last State]
Power On By PCIE [Disabled]
[Disabled]
[Enabled]
Power On By Ring [Disabled]
[Disabled]
[Enabled]
This item functions only if there is a serial port (COM1) connector on the motherboard.
Power On By RTC [Disabled]
[Disabled]
[Enabled]

SMART Settings

SMART Self Test [Enabled]
Allows you to run SMART Self Test on all HDDs during POST.
Configuration options: [Disabled] [Enabled]
3-24
Disables the PCIE devices to generate a wake event.
Enables the PCIE devices to generate a wake event.
Disables the Ring devices to generate a wake event.
Enables the Ring devices to generate a wake event.
Disables RTC to generate a wake event.
W hen set to [Enabled], the items RTC Alarm Date (Days) and Hour/Minute/
Second will become user-configurable with set values.
Chapter 3: BIOS Setup