Sony CMT-HPX11D Operating Instructions Manual page 9

5 Connect the power cord to a wall
outlet.
If the plug does not fit the wall socket,
detach the supplied plug adaptor (only for
models equipped with an adaptor).
To turn on the system, press ?/1.
6 Set the color system to PAL or NTSC
depending on the color system of your
TV.
The color system is factory set to NTSC for
region code 3 models, and PAL for other
region code models. Each time you perform
the procedure below, the color system
changes as follows:
NTSC y PAL
1
Press ?/1 to turn off the system.
2
Press ?/1 on the unit while holding
down lm on the unit.
The system turns on and the color
system is changed.
Notes
• You cannot set the color system in Power Saving
Mode (page 43).
• When playing back a Video CD recorded in a
different color system from the one you set for this
unit, the picture may appear distorted.
Inserting two R6 (size AA)
batteries into the remote
Operating a Sony TV
You can use the following buttons on the remote
to operate a Sony TV.
To
Turn the TV on or off
e
E
E
e
Press
TV ?/1
To
Switch the TV's input source
between the TV and other input
sources
Change the TV channels
Adjust the volume of the TV
speaker(s)
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Tip
With normal use, the batteries should last for about six
months. When the remote no longer operates the
system, replace both batteries with new ones.
When carrying this system
Perform the following procedure to protect
the DVD mechanism.
1
Press ?/1 to turn on the unit, then switch
the function to DVD.
2
Check the following:
• All discs are removed from the system.
• The disc tray is closed.
3
While holding down EX-CHANGE, press
?/1.
Check that "PLEASE WAIT" then "LOCK" is
displayed.
4
Unplug the power cord.
Press
TV/VIDEO
TV CH +/–
TV VOL +/–
GB
9