Troubleshooting; Radio Dimensions - REI EVR-6500D Installation & Operation Manual

6.2” touch screen am/fm multimedia receiver with cd/dvd, usb, ipod, auxiliary a/v inputs, & bluetooth audio streaming
Table of Contents

Advertisement

TROUBLE SHOOTING
Problem
Unit will not power on.
Cannot tune radio stations.
USB media not playing, or says Invalid File
Type.
Cannot stream Bluetooth® audio.
Audio is distorted or low.
iPod® screen displays "iPod Linking" for
a long period of time.
Disc's will not play or display loading for
an extended period.
Rear view Camera is not displayed
Touch screen operation is not functioning
correctly

RADIO DIMENSIONS

Cause
No power to BATTERY wire or ACC wire,
blown 10A main fuse or 1A accessory fuse.
The antenna cable is not connected. The
signal is too weak. The radio is in the
wrong frequency AREA.
Media is the wrong file type.
Bluetooth® device was not successfully
paired. Verify RED Bluetooth® connected
icon.
Source audio level is too weak or
overdriven. Bitrate of audio file is too large.
iPod® is not a supported device.
DVD-R and DVD-RW will not play unless
the disc is finalized after authorizing in
software.
Camera not working or trigger is not
connected properly.
Front display is dirty front or requires
calibration.
Solution
Check for both ACC & BATTERY voltage
with Multi-meter, check all fuses.
Connect the antenna cable. Check that the
RADIO AREA is set to the correct location.
Convert files to a usable format, see file
requirements section of the manual.
Pair the Bluetooth® device following the
steps in the manual and retry.
Adjust the volume level of the auxiliary
source. Check the VOLUME BALANCE
section of SETUP. Change the sample
frequency or Bitrate of the file.
Wait for iPod® to load or reconnect 30-pin
plug. If still Linking, then device is not
supported, use the AUX input or a
Bluetooth® connection instead.
Finalize the media before playing in the unit.
Verify that the files meet the requirements of
the Radio.
Verify camera has power and that the trigger
is connected properly.
Gently wipe the front display. Enter the
SETUP menu and calibrate the screen.
Page | 30

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vr-6000d

Table of Contents