Advertisement
Operation Guide 5406
* UTC: Universal Time Coordinated;
GMT: Greenwich Mean Time
Based on data as of December 2014.
Important!
To check the current time in a location that is not among the 29 city names, select
a city that is in the same time zone as the one you want to check.
Example: To check the time in Osaka (Offset: +9), select Tokyo, which has the
same offset.
To check the current time in a city where summer time is in effect, select a city in a
time zone with a time that is one hour ahead of the desired city.
Example: To check the time in NEW YORK (Offset: –5) during summer time, select
SANTIAGO (Offset: –4).
E-20
To enter the Stopwatch Mode
Refer to the Mode Reference Guide (page E-8).
Entering the Stopwatch Mode will cause the 6 6 Lower Dial Hand to move to ST.
To measure elapsed time
A
A
A
Start
Stop
(Resume)
To pause at a split time
A
B
B
Start
Split
Split release
E-22
Using the Countdown Timer
The countdown timer can be confi gured within a range of one minute to 24 hours.
An alarm sounds for about 10 seconds when the timer reaches zero.
Hand Functions
3 3
4
5 5
1 1 Hour Hand
6
1
2
2 2 Minute Hand
3 3 Second Hand: Indicates countdown seconds.
4 4 Small Hour Hand: Indicates countdown hours.
5 5 Small Minute Hand: Indicates countdown minutes.
30
6 6 Lower Dial Hand: Points to TR.
All hands move counterclockwise during a countdown.
E-24
To perform a countdown timer operation
A
A
Start
Stop
Pressing B while the Countdown Timer is stopped resets the displayed time to
the start time specifi ed by you.
Pulling out the crown while a countdown operation is in progress will stop the
ongoing operation so you can change the countdown start time setting.
To stop the alarm
Press any button.
E-26
Important!
Check the points below before using the alarm.
− Make sure the current time setting is correct (page E-12).
To enter the Alarm Mode
Refer to the Mode Reference Guide (page E-8).
Entering the Alarm Mode will cause the 6 6 Lower Dial Hand to move to ON or
OFF.
E-28
Using the Stopwatch
The stopwatch measures elapsed time and split times, and two fi nishes.
1 4 3 3
To measure two fi nishes
A
Start
A
B
(Stop)
Reset
Note
The Stopwatch Mode can indicate elapsed time up to 23 hours, 59 minutes,
A
B
59.95 seconds. Elapsed time measurement will stop automatically when the
maximum time is reached.
Stop
Reset
The 6 Lower Dial hand will move for 60 seconds after you start an elapsed time
operation. After that, it will stop at 0. When you stop the elapsed time operation,
the 6 Lower Dial hand will move to the 1/20-second reading for the current
elapsed time.
To enter the Countdown Timer Mode
Refer to the Mode Reference Guide (page E-8).
Entering the Countdown Timer Mode will cause the 6 6 Lower Dial Hand to move
to TR.
To specify the countdown start time
Using the Alarm
B
When the alarm time is reach in the Timekeeping Mode, the watch sounds an alarm
for 20 seconds. You can also set an alarm for one of the World Time cities (World
Reset
Time Alarm).
1
To change the alarm time setting
1. In the Alarm Mode, pull out the crown to the fi rst click.
Example: TYO
(Same as Home City)
1
Hand Functions
5 5 2 2
1 1 Hour Hand
2 2 Minute Hand
3 3 Second Hand:
Indicates stopwatch elapsed time measurement in
30
1/2 (0.5)-second units.
4 4 Small Hour Hand:
Indicates the stopwatch hour count.
5 5 Small Minute Hand:
Indicates the stopwatch minute count.
6
6 6 Lower Dial Hand:
Indicates the 1/20 (0.05)-second count.
B
A
Split
Stop
First runner
Second runner
fi nishes.
fi nishes.
Display time of fi rst
runner.
1. In the Countdown Timer Mode, pull out the crown
4 4
5 5
to the fi rst click.
2. Use A and B to move the 4 4 Small Hour Hand
and 5 5 Small Minute Hand to the desired start
time.
Holding down A (–) or B (+) will move the
30
hands at high speed.
3. Push the crown back in.
Hand Functions
5
4
2
1 1 Hour Hand
2 2 Minute Hand
3 3 Second Hand: Indicates the city for which the alarm
time is set (Alarm City).
4 4 Small Hour Hand: Indicates the currently set alarm
30
5 5 Small Minute Hand: Indicates the currently set alarm
6 6 Lower Dial Hand: Indicates the current alarm ON/
3
6
2. Use A to select the Alarm City.
Each press of A advances to the next city.
To set an alarm based on your Home Time
4
5
2
(indicated by the 1 1 Hour Hand and 2 2 Minute
Hand), select your Home City (page E-15) as the
Alarm City. To set an alarm based on your World
Time (indicated by the 4 4 Small Hour Hand and
5 5 Small Minute Hand), select your World Time
30
City (page E-17) as the Alarm City.
See the city list on page E-19.
While summer time is in effect in the desired time
zone, change to the time zone whose time is one
hour ahead.
6
3
E-21
B
B
Split release
Reset
Display time of
second runner.
E-23
E-25
time hour.
time minute.
OFF setting.
E-27
E-29
Advertisement
