INSTALLATION
After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-Sales Service.
PREPARING THE CABINET FOR FITTING
WARNING
•
Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could
damage them.
•
The distance between the underside of the appliance and the separator panel must respect the dimensions given in the figure.
•
In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit.
•
Do all cabinet cutting work before fitting the hob, and carefully remove any shavings or sawdust.
ELECTRICAL CONNECTION
WARNING
-
The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the
regulations provided in this chapter.
-
The power cable must be long enough to allow the hob to be removed from the worktop.
-
Make sure the voltage specified on the dataplate located on the bottom of the appliance is the same as that of the home.
-
Do not use extension cords.
Connection to the terminal block
Hob is already provided with two power supply cables 5 x 2,5 mm
Connect the cables to the two terminal blocks on the underside of the appliance.
IMPORTANT: only for 400 V 3N connection~ use one power supply cable only (connecting it to the terminal block of the main electronic module) in addition to 3 x 1.5 mm
for connecting the main terminal block to that of the auxiliary electronic module. For electrical connection, follow the instructions enclosed with the 3 x 1.5 mm
For the electrical connection, use an H05RR-F cable as specified in the table below.
-
Install a separator panel under the hob.
-
The lower part of the product must not be
accessible after installation.
-
In case of installation of an undertop oven,
do not interpose the separator panel.
-
Disconnect the appliance from the power supply.
-
Installation must be carried out by qualified personnel who know the current safety and installation
regulations.
2
the instructions included in the supply cable bag.
400 V 3N ~
2
3 x 1.5 mm
230 V ~ / 230-240 V ~ / 400 V 2N ~ / 230 V 3 ~
EN16
min. 20 mm
min. 5 mm
2
wiring
2
wiring.