WaterGroup WG185ACF75 Owner's Manual page 6

6
Where To Install The Filter
Place the filter tank as close as possible to

the pressure tank (well system) or water
meter (city water).
Place the filter tank as close as possible to

a floor drain, or other acceptable drain
point (laundry tub, sump, standpipe, etc.).
Connect the filter to the main water supply

pipe BEFORE the water heater. DO NOT
RUN HOT WATER THROUGH THE FIL-
TER. Temperature
through the filter must be less than 100
deg. F.
Do not install the filter in a place where it

could freeze. Damage caused by freez-
ing is not covered by the warranty.
Put the filter in a place water damage is

least likely to occur if a leak develops. The
manufacturer will not repair or pay for wa-
of water passing
ter damage.
A 120 volt electric outlet, to plug the in-

cluded transformer into, is needed within 6
feet of the filter. The transformer has an
attached 6 foot power cable. Be sure the
electric outlet and transformer are in
an inside location, to protect from
wet weather.
If installing in an outside location, you

must take the steps necessary to assure
the filter, installation plumbing, wiring,
etc., are as well protected from the ele-
ments, contamination, vandalism, etc., as
when installed indoors.
Keep the filter out of direct sunlight.

The sun's heat may soften and distort
plastic parts.