System Start Up - WaterGroup WG185ACF75 Owner's Manual

10
Key Pad Configuration
SETTINGS This function is to enter the basic set up infor‐
mation required at the time of installation.
MANUAL This function is to initiate an immediate or
REGEN delayed manual regeneration.
DOWN / Increase or decrease the value of the settings
UP while in the programming mode.
Manual Regeneration (Step / Cycle Valve)
DELAYED REGENERATION
Press and release the MANUAL REGEN. But-
ton to set a delayed regeneration that will
occur at the regeneration time. The main
display page will show DELAYED REGEN ON.
To cancel press and release the MANUAL RE-
GEN. Button. The main display page will
show DELAYED REGEN OFF.
Start-up Instructions
1. Plug the valve into an approved power source.
2. When power is supplied to the control, the screen will display "INITIALIZING WAIT
PLEASE" while it finds the service position.
3. Start an Immediate Manual Regeneration. The valve will immediately start moving to the
BACKWASH position.
4. Open the inlet on the bypass valve slightly and very slowly allow water to en-
ter the unit. (If the water enters too quickly it will push the carbon up into the
control valve and get plugged).
5. Once the unit has filled sufficiently that water is at least equal to the height of
the top of the media shut down the water for 15 – 20 minutes for the carbon
to soak. Unplug the power cable. After the carbon has soaked for the recom-
mended time continue by plugging the power cable back in.
6. Press any button to advance to the RINSE position. Check the drain line flow. Allow the
water to run for 3-4 minutes or until the water is clear.
7. The valve will automatically advance to the SERVICE position after the RINSE cycle is
complete. Open the outlet valve on the bypass, then open the nearest treated water fau-
cet and allow the water to run until clear, close the tap and replace the faucet screen.
8. Program time, date, and number of days between regenerations into controller using
Programming Instructions
System Start-Up
IMMEDIATE REGENERATION
To start an immediate regeneration (or step
valve through each position), press and hold
the MANUAL REGEN. Button for 3 seconds
(until beeps). The valve will start an immedi-
ate regeneration. Press any key to skip to
the next cycle.
SETTINGS MANUAL
REGEN
UP DOWN