Safety - Braemar SACC Series Owner's Manual

SAFETY

Congratulations on purchasing a new
Braemar Air Conditioner!
Please keep this Manual and the
Warranty Booklet in a safe place,
along with the original purchase
documents, plus all relevant
certificates of compliance relating to
the installation work performed. Please
register the Warranty straight away, by
following the steps set out in the
Warranty Booklet.
The Braemar Add-On Cooling Unit is a
refrigerated cooling only, split type air
conditioning system, designed
specifically for connection to a
Braemar "TH/THM Extra Air" Series
gas ducted heating unit, using ONLY
Braemar Spectrolink Comfort Control.
The installer must read the Installation
Manual before installing the Braemar
Add-On Cooling Unit. The home
owner/user should read the Owner's
Manual before operating the Unit.
To ensure the warranty on the Unit is
continued and valid, the Unit must be
checked and serviced by the home
owner/user as per the requirements in
the Maintenance & Service section
and the Maintenance Schedule. This
will also prolong the life of your air
conditioner.
The home owner/user should regularly
check the Air Inlet side of the Outdoor
unit (see the diagram on page 1) to
ensure grass, leaf and other matter are
not drawn into or onto the Inlet side of
the Outdoor unit. Restriction to the air
flow across the coil will reduce the
system's capacity, and result in high
2 SACC Series Add-On Cooling Unit
operation pressures and excessive
operating costs.
A return air filter MUST be installed by
the installer at the return air grille. The
air filter should be inspected and
cleaned at least every two weeks
during summer or other periods when
the Braemar Add-On Cooling Unit is
used. Note: the manufacturer
recommends that low level return air
grilles are installed.
IMPORTANT!
THE AUSTRALIAN GREENHOUSE
OFFICE HAS ISSUED VARIOUS
REGULATIONS ON THE USE AND
DISPOSAL OF REFRIGERANTS IN
THE UNIT. FAILURE TO FOLLOW
THESE REGULATIONS MAY HARM
THE ENVIRONMENT AND COULD
LEAD TO THE IMPOSITION OF
SUBSTANTIAL FINES.
WHERE SPECIFIED, ONLY
QUALIFIED AND LICENSED
TECHNICIANS SHOULD PERFORM
WORK ON THIS UNIT, FAILING
WHICH THE WARRANTY ON THE
UNIT WILL BE VOID.