Table of Contents
Advertisement
Appendix
B
Message List
The following messages and indications may appear for this camera. Perform the following as
necessary.
Lamp display
Lamp
The STANDBY lamp and
POWER lamp are lit.
The STANDBY lamp is lit. If the camera is moved forcibly, or a finger or other object interferes
Screen display
Message
PRESET n:OK
("n" is a preset position
number between 1 and 16)
RECALL n:OK
("n" is a preset position
number between 1 and 16)
RESET n:OK
("n" is a reset position
number between 1 and 16)
ONE PUSH WB:OP
ONE PUSH WB:OK
ONE PUSH WB:NG
30
Message List
Meaning and solution
The SYSTEM SELECT switch is set to "no output" (page 9).
with camera movement, the camera's built-in processor may fail to
memorize the pan/tilt position.
Press the PAN-TILT RESET button to reset the pan/tilt position.
Meaning and solution
This message appears for about 3 seconds when you store camera
settings to POSITION 1 to 16.
The preset position number of the infrared remote commander is
POSITION 1 to 6.
This message appears for about 3 seconds when you read the camera
settings stored in POSITION 1 to 16.
The preset position number of the infrared remote commander is
POSITION 1 to 6.
This message appears for about 3 seconds when you reset camera
settings stored in POSITION 1 to 16.
The preset position number of the infrared remote commander is
POSITION 1 to 6.
During the white balance adjustment in the ONE PUSH white
balance mode, this message blinks on the screen.
When the white balance adjustment has been done correctly in the
ONE PUSH white balance mode, this message is lit on the screen.
When the white balance adjustment has failed in the ONE PUSH
white balance mode, this message blinks on the screen.
Hide quick links:
Advertisement
Table of Contents
