Finding A Work Area; Unpacking Your Laminator - D&K Group EXP 62 Plus Owner's Manual

Find a Work Area
A separate work station is required to house your laminator. Ample room is
necessary to access the laminator from all 4 sides. If the laminator is back
against a wall, the laminating film may back up and jam the equipment. Your
laminator must be on a stable, level surface.
Tools necessary to set up your laminator include cutting shears and any
adhesive tape. For future service or maintenance, an assortment of Allen
wrenches, a flat head screwdriver and a Phillips head screwdriver are
necessary.

Unpacking Your Laminator

The shipping carton contains:
1 Laminator
1 Top Supply Mandrel
1 Bottom Supply Mandrel
1 Release Liner Rewind Mandrel
1 Feed Table
1 Operating Handbook
Be sure to save the shipping carton . . .
Should your laminator ever need to be returned for service, the foam-filled
carton ensures safe transit.
NOTE: Each laminator is test run after it is assembled. Your laminator may have
a piece of test film in the rollers when you receive it. If so, before threading,
remove the test film by turning the drive switch to "ON". The test film will exit
the laminator.
Laminator.com www.laminator.com
- 4 -