D&K Group EXP 62 Plus Owner's Manual page 4

Safety Precautions
Do not operate laminator with any panels or guards removed. Panels and
guards protect operators from such moving parts as the drive chain and
sprockets, roller ends, etc.
Turn the power switch OFF before walking away or leaving the laminator
unattended.
Before lifting or moving laminator, turn power switch OFF, unplug unit and
allow to cool to room temperature. Remove film rolls before lifting or moving
machine. Film is easy to rethread, see the section in this manual.
Keep children away. Make sure visitors are kept well back from an operating
laminator.
Do not abuse electrical cord. Never pull cord to disconnect it from a
receptacle. Do not allow cord to contact heat, oil or sharp edges. Do not cut
off or otherwise bypass the grounding prong on the plug.
If an extension cord is necessary be sure it is properly rated and of the same
wire gauge or smaller as the laminator cord. Capacity of the cord must
prevent loss of power and overheating. Before using, inspect extension cord
for any damage, including loose or exposed wires, broken fittings, damaged
insulation, etc.
For service on your laminator call D&K Group Inc.. Use only D&K Group Inc.'s
parts for service or replacement. Failure to use D&K Group Inc.'s parts could
void manufacturer's warranty.
Use common sense. Be cautious when operating your laminator. Do not
operate laminator when you are tired or your reactions are impaired in any
way.
Do not allow anyone to operate the laminator who has not received proper
instruction and has not read the safety instructions
Laminator.com www.laminator.com
- 3 -