Mounting And Laminating Using A Superstick® Pouch Board - D&K Group EXP 62 Plus Owner's Manual

Mounting and Laminating using a SuperStick® pouch board:
1. Refer to the instruction sheet packed with each box of SuperStick® pouch
boards for specific instructions on mounting/laminating with a SuperStick®
board.
2. Also, refer to the instruction sheet for information on Compatible Media,
Process Conditions, and Technical Information.
3. A SuperStick® Pouch Board consists of a foam mounting board with a
piece of film on top. The film is sealed to the board along one side of the
shorter sides.
4. Carefully examine the board, determine which edge is sealed. There is a
1/8" tape edge on the sealed end.
5. Starting at one of the corners opposite the sealed edge, gently lift and
peel back the film. Care should be taken not to break the sealed hinge.
6. Center the image to be laminated on the board and lay the film back
over it.
7. Cover your print with the cover sheet packed in each box as marked. This
is required on thick papers to prevent adhesive from sticking to the rolls.
8. Set the control knob to the correct setting that matches the pouch board
thickness.
9. Slowly insert the pouch board into the inlet opening. Ensure that the pouch
board will enter centered and straight. A gentle push may be required to
start the board into the machine. Hold the edges of the pouch board until
it is engaged and the laminator begins pulling on its own.
10. The pouch board will feed through the laminator and automatically exit at
the rear of the unit.
11. Support board as it exits the machine to keep heated board from curling
down.
THE POUCH BOARD WILL BE HOT!
12.
13. If there is any dirt or adhesive on the surface of the board, it can be
removed by dampening a lint free cloth with Poly-Off and wiping the
surface.
Laminator.com
Allow it to lie flat while cooling.
- 12 -
www.laminator.com