Encapsulating With A Superstick® Flexible Pouch Or Release Board - D&K Group EXP 62 Plus Owner's Manual

Encapsulating with a SuperStick® Flexible Pouch using a SuperStick® Sled or
release board:
1. Refer to the instruction sheet packed with each box of SuperStick® Flexible
pouches for specific instructions on encapsulating.
2. Also, refer to the instruction sheet for information on Compatible Media,
Process Conditions, and Technical Information.
3. The Flexible Pouch consists of two pieces of film that are hinged at one
end, along a short side. Separate the two pieces starting at the end
opposite the hinge. Take care not to break the hinged seal.
4. Insert the article to be laminated in the pouch so there is at least a 1/8"
(3mm) border around each of the sides. This ensures that moisture never
reaches the image.
5. Place the pouch with the image on the release carrier board included
with the flexible pouches or SuperStick® sled carrier. The SuperStick® sled
is carrier board to assist in the handling of large Flexible Pouches. It is
made of materials that will not damage or cause excessive wear to the
EXP 62" Plus Laminators.) Smooth out any wrinkles with the
hand or a soft, flexible squeegee.
6. Better results may be achieved by taping the leading edge of the pouch
to the sled using masking tape.
7. Adjust the Control Knob to the 3/16" setting for the SuperStick® Sled or
1/16" for the release carrier board to accommodate its thickness. Be sure
that the heat is on, the middle LED indicator is on and the bottom LED is
constantly on.
8. Slowly insert the sled or release carrier board with the Flexible
Pouch on top into the inlet opening. Ensure that the sled or release board
is centered and straight. A gentle push may be required to start the sled
or release board into the machine. Hold the edge of the sled or release
board until it is engaged and the laminator begins pulling it on its own.
9. The sled or release board will feed through the laminator and
automatically exit at the rear of the machine.
10. THE SLED or RELEASE BOARD WILL BE HOT!
before removing the tape.
If there is any dirt or adhesive on the surface of the board, it can be removed
by dampening a lint free cloth with ISO Propyl Alcohol (IPA) and wiping the
surface.
Laminator.com
Allow it to lie flat and cool
- 13 -
side of the
www.laminator.com