Nip Adjusters Diagram - D&K Group EXP 62 Plus Owner's Manual

Nip Adjusters
The Nip Adjusters are Located on the left hand side of the laminator and are
operated from front and rear of the machine. The Nip Adjusters are used to
adjust the height of the rollers.
To Operate the Nip Adjusters:
Grasp it with your left hand and pull out approximately 1/4"
Once the Nip Adjusters have disengaged from the stop, they may be
rotated forward or backward (clockwise or counter-clockwise, as viewed
from the left hand side of the unit).
To Set the Height of the Rollers:
Continue to rotate the Nip Adjusters until the desired measurement
corresponds with the indicator of the knob.
Select the measurement that indicates the thickness of the material you
will be using with the machine.
Release the Nip Adjusters so that it moves back to the right and clicks
into place, this will set the rollers for use.
The measurements on the Nip Adjusters, ½", ¼" (6mm), 3/16" (5mm), 1/8"
(3mm) and 1/16" (1.5mm) correspond to board thickness'.
For additional pressure, stop Nip Adjusters between indicated
thicknesses.
There is also a fully closed stop, 0" (0mm) for encapsulating applications.
For additional pressure when rollers are closed, pull knob out & rotate
counter clockwise to increase pressure.
Note: Do not apply additional pressure to rear (Pull) Rollers
Rear Pull Rollers operate best with minimal pressure.
Laminator.com
- 10 -
www.laminator.com