Mighty Mule FM502 Installation Manual page 43

ADDITIONAL Accessories
Photo Beams [R4222]
Primary "through beam" photo beam device. Provides "non-contact" entrapment
protection.
Pin Lock [FM345]
Use as a substitute for the clevis pin at the front mount of the gate opeator to prevent
theft of the operator.
Push Button Control [RB101]
Wire this unlit push button directly to your gate operator for simple open/close/stop
operation from up to 1000 ft. away. Use 16 gauge low-voltage wire.
Replacement Transformer [RB570]
Standard 18 volt, 2200 mA AC transformer included with the gate operator to maintain
battery charge.
HARDWARE Accessories
Push To Open Brackets [347IH]
Required when the gate operator must push a gate open (arm extends to open), such
as away from a sloping driveway or where space prevents gate from opening into the
property (pull to open). Order two brackets for a dual swing gate installation.
Column Mount Lock Receiver [433IH]
For use with the Automatic Gate Lock or Bulldog Pedestrian Gate Lock when mounting
on brick columns or applications with limited space.
If you have a question about any special order item,
The contents of all material available on this installation manual are copyrighted by GTO Access Systems, LLC ("GTO"), unless otherwise indicated. All
rights are reserved by GTO, and content may not be reproduced, downloaded, disseminated, published, or transferred in any form or by any means, except
with the prior, written permission of GTO. Any reprinting of GTO publications is by permission only. Copyright infringement is a violation of federal law.
Mighty Mule¨, E-Z Gate¨, GTO¨, are registered trademarks of GTO Access Systems, LLC America's DIY Automatic Gate Openers is a trademark of GTO
All rights are reserved by GTO, and these marks may not be used, in any for without the prior, written permission of GTO.
• Pin Lock 10-pack: ten Pin Locks keyed alike [FM345KA].
just call 1-800-543-GATE!
and are the exclusive property of GTO Access Systems, LLC.
39