GE RAK348T1 Owner's Manual page 4

Introduction.
This two-part wireless thermostat system is designed to provide remote temperature control.
Powered by four AA batteries, the thermostat will operate for approximately 1 year and can be
mounted in any suitable location that will ensure good temperature control. A large LCD display
provides the user with current space temperature, set point temperature and system status
information. The second part of the system is the receiver. The receiver interfaces with the
desired HVAC equipment and communicates with its thermostat using unlicensed 900MHz
radio frequency energy. At the time of installation, the thermostat is linked to one or more
receivers. A thermostat and receiver that have been linked will not interfere with or be affected
by any other thermostat or receiver in adjacent rooms, apartments or neighboring homes.
Batteries.
Installing/Changing
A low-battery icon
being exhausted. The thermostat is designed to use standard AA-size 1.5-volt batteries. If the
batteries are depleted, the heating/cooling system will go to the OFF state.
Replacing Batteries
To open the thermostat, remove the security screw
(#2 Phillips or #2 security screw). Using both hands,
press the two push tabs on the bottom of the
thermostat housing, while pulling the front of
the thermostat away from the base.
The thermostat operates with 4 AA batteries.
Batteries are paired, one set on top of the other.
4
will light on the thermostat display when the batteries are close to
Thermostat
opened back
Thermostat
cover
Latches and
security screw
Circuit Board
Set A Set A
Set B
Set B
Base plate
Thermostat will operate
on either Set A, Set B
or both. When changing
batteries, replace one
set at a time to avoid
losing the set point
information. Always
replace with all new
batteries. Never use
a mix of old and new.
Battery orientation
is critical.