Advertisement
19
Lift Canopy to ceiling aligning the key hole slots
with the screws on the bottom of the Mounting
bracket. Rotate the canopy Counter Clockwise
to lock in place. Tighten the screws to secure
the Canopy. See inset for Keyhole shape
22
Check the motor for plastic shipping stabilizer
tabs, and remove them if they are present. The
screws, washers, and motor pads are pre-
installed to the blade holders. Attach blade
assembly to motor and tighten screws securely.
25
Connect plug from fan to switch house plug.
20
Place floating brackets onto blades aligning
holes in blade with the floating bracket.
23
Loosen 4 screws with slots and remove the
other screw.
26
Loosen 3 screws with slots and remove 2 with-
out slot. Place switch housing over 3 screws
and twist into place. Tighten the 3 screws with
slots and replace and tighten the 2 removed.
21
Place blade arms onto the other side of the
blade and aligning holes. Insert screws with
fabric washers though the holes and tighten
securely.
24
Place fitter plate on screws and twist into place.
Tighten the 4 screws with slots and replace the
other screw.
Advertisement
