Table of Contents
Advertisement
5.4 PTZ Controller
Connect the data cable of RS-485 to EN320. When the
camera is successfully connected, the video image will
be displayed on the LCD panel. Use navigation keys to
remotely control the directions and angles of PTZ
camera, or use FAR / NEAR / TELE / WIDE function keys
to control the camera function.
Press
to bring up the sub menu, and use navigation
keys to setup Address / Protocol / Baud / S-PS / C-PS /
Pan Speed / Tilt Speed, and select video source from PTZ
Input Signal.
Set Preset Position
Use navigation keys to move to the desired position, then press
to S-PS to select a preset number. When finished, press
Call Preset Position
Press
to bring up the sub menu and go to C-PS to select a preset number. Press
PTZ camera to the preset position.
5.5 CVBS Pattern Generator
When switch to this function, the pattern generator will
turn on automatically and output a color-bar pattern via
BNC video output port. Connect this pattern to the cable
to check if the signal cable in camera end to DVR is
installed properly.
Press
to bring up the submenu and switch NTSC /
PAL signal format by navigation keys.
to bring up the sub menu and go
to save the setting.
5
EN320
to force the
Advertisement
Table of Contents
