Lincoln Electric PF42 Operator's Manual page 13

Setting and Configuration Menu
To access the menu, press the the Left [29] and the
Right [27] Buttons simultaneously.
Note: The Menu cannot be accessed if the system is
welding, or if there is a fault (status LED is not solid
green).
Parameter Selection Mode – the Parameter Name on
the Left Display [18] blinking.
Table 5. Interface Components and functions when the Settings and Configuration Menu is active.
18
32
Figure 9
English
29 28
27
Figure 8.
Parameter Change Value Mode – the parameter value
on the Right Display [21] blinking.
Note: To exit the menu with changes saved, press the
Left [29] and the Right [27] Buttons simultaneously.
Note: After one minute of inactivity the Menu without
saving will also exit.
21
24
User has access to two menu levels:

Basic Level – basic menu which is connected with
setting the Welding Parameters.

Advanced Level – advanced menu, configure device
menu.
Note: The availability parameters [18] in the Setting and
Configuration Menu depend on the selected welding
program / welding process.
Note: After the device has been restarted the user
settings are restored.
10
Functions of Interface
Components
18. Parameter Name.
21. Parameter Value.
24. Changing Parameter Value.
27. Entering to Parameters
Editing.
Confirm Parameter Value
change.
28. Setting and Device
Configuration Menu is active.
29. Cancelation / Back.
32. Parameter Selection.
English