ReSound Phone Clip+ User Manual page 8

here.
1. Turn you Phone Clip+ ON and remove the silver cap. Place
your mobile phone next to the Phone Clip+, and make sure
your phone is ON.
2. Find the connectivity settings on your phone. Look for the
"Bluetooth" feature in the main menu or one of the sub
menus, such as "Connectivity".
3. On your mobile phone, ensure that Bluetooth is turned ON.
4. With the tip of a pen or similar object, press the small blue
Bluetooth pairing button one time on the back of your Phone
Clip+ (see picture below). Now the Phone Clip+ will be in
Bluetooth pairing mode for two minutes.
5. On the mobile phone choose to search for Bluetooth devices.
6. Your mobile phone should present a list of Bluetooth devices
discovered. select "Hearing Aid Phone" from this list.
7. Your mobile phone may
then ask you to enter a
passcode. if so, enter
"0000" (four zeros).
14
Your Phone Clip+ should now be paired to your
mobile phone. some mobile phones may ask which Bluetooth
service you wish to enable. select "Headset".
Connecting
Once your mobile phone and Phone Clip+ are paired, the mobile
phone may need to be connected before it will actually send the
appropriate audio signals.
This function should also appear in your mobile phone's "Blue-
tooth" menu, usually under a list of "Paired devices". in that list,
highlight your Phone Clip+ and select "Connect".
When your Phone Clip+ and mobile phone are connected, you
may see a headset symbol on the main screen of your mobile
phone, similar to this:
The connection between the Phone Clip+ and the mobile phone
will be maintained for as long as both devices are turned ON and
remain within range of each other. if either device is switched
OFF or gets out of range, you may have to perform the connec-
tion procedure again.
On some phones you can configure "Automatic reconnection".
We recommend that you do so if the feature is available. refer to
the user guide of your mobile phone for instructions on how to
do this if supported.
15