Safety Information - NC HT1.0 Original Instructions Manual

IF THE DUMPER DEVELOPS A FAULT
• Park the machine in a safe area if possible. If this is not possible take measures to warn
others of the machine position.
• Remove the start switch key.
• Contact a qualified person to rectify the fault.
• Do not place any part of the body in any area of the machine where there is a hydraulic
leak while the system is pressurised.
THE REPAIR AREA
• The repair area should be level, clean, dry, well ventilated and have adequate lighting
• Keep the floor clean, wipe up spilt oil and grease.
• Always use the correct tool for the job, keep tool in good condition.
NEVER IMPROVISE TOOLS.
• Jacks, hoists, lifting chains and ropes should be checked before use. Do they have
sufficient lifting capacity and are they properly certified.
• Do not attempt to lift heavy objects on your own.
WHEN REPAIRING
• Safety prop raised / tipped skips.
• Always wear eye protection.
• Always wear ear protectors when in a noisy environment.
• Release any pressure from the hydraulic system before carrying out repairs.
• If the machine is lifted or suspended always support the machine on suitable blocks.
• Always remove the start switch key to prevent accidental starting.
• Never work with the engine running unless absolutely necessary.
• Never start the engine unless in a well ventilated area. Carbon Monoxide fumes can
KILL.
• Always exercise extreme caution when welding, grinding or burning against risk of fire.
Keep suitable fire extinguishers near by.
• Never smoke or leave the engine running when refuelling.
• Always use genuine spares from NC Engineering.
• Always check and test the machine thoroughly before putting it back to work.
Observing these points will help to ensure the repair of the dumper is as safe as
possible. Only trained persons should carry out repairs.
FOR YOUR SAFETY
35