Connecting Front Speakers That Support Bi-Amp Connections - Yamaha aventage RX-AS710 Owner's Manual

1 2 3 4 5 6 7 8 9 10 11
Connecting front speakers that
support bi-amp connections
When using front speakers that support bi-amp
connections, connect them to the FRONT jacks and
ZONE2/F.PRESENCE/SURROUND BACK/BI-AMP jacks.
To enable the bi-amp function, set "Power Amp Assign"
(p.105) in the "Setup" menu to "5ch BI-AMP" after
connecting the power cable to an AC wall outlet.
The unit (rear)
2
ANTENNA
SURROUND CENTER FRONT
(RADIO)
M AM
SUBWOOFER
PRE OUT
1 2
3
9
4
• The FRONT jacks and ZONE2/F.PRESENCE/SURROUND
BACK/BI-AMP jacks output the same signals.
Caution
• Before making bi-amp connections, remove any brackets or
cables that connect a woofer with a tweeter. Refer to the
instruction manual of the speakers for details. If you are not
making bi-amp connections, make sure that the brackets or
cables are connected before connecting the speaker cables.
• Surround back speakers cannot be used during bi-amp
connections.
SPEAKERS
EXTRA SP
ZONE2 / F.PRESENCE
SURROUND BACK / BI-AMP
5
20
En