Specifications; Troubleshooting - Tecknet M001 User Manual

Specifications

Button Count:
Operating Frequency:
Resolution:
Receiver interface:
Operating Voltage:
Operating Current:
Operating Distance:

Troubleshooting

What do I do if the mouse does not work?
• Ensure that the polarity of the batteries is correct. The positive (+) and
negative (-) ends of each battery must match the positive (+) and
negative (-) markings in the battery housing.
• Make sure the batteries are not discharged.
• Remove the batteries and reinstall the batteries again.
• Verify that your computer's power management feature is turned off.
• Ensure the Nano Receiver's USB connector is firmly attached to the
PC's USB port.
The USB Nano Receiver is recognized by Windows
(Windows2000, 2003,XP,Vista,Win7,Win8,Mac10.x) but
the cursor does not move
• Check whether the low power indicator on the top of the Mouse keeps
flashing. If the sensor lights up, it is likely that the batteries are
discharged. Please replace them.
• If replacing the batteries does not help, it is likely that the Mouse is
not connected to the Nano Receiver. Please remove the Nano
Receiver and plug in again or remove the battery and re-install.
When I use the Mouse other 2.4G cordless devices work
more slowly or fail temporarily – what should I do?
• The mouse may cause interference with any cordless, radio-based
device that operates at 2402MHz - 2480MHz, such as a 2.4G
telephone, 2.4G baby monitors, 2.4G cordless routers and toys. To
reduce interference, move the Nano Receiver and the base unit of the
affected device as far away from each other as possible. Alternatively
try to change the 2.4G frequency of the affected devices.
3 buttons
2.4GHz
1000/1500/2000DPI
USB version 2.0
1.5V
6.8mA
up to 10m