Table of Contents
Advertisement
IV. INSTALLATION INSTRUCTIONS FOR CEILING
FAN REMOTE CONTROL
A. IMPORTANT POINTS:
1.
Please read this manual and keep it for future use.
2.
Turn off the electrical mains at the circuit breaker/fuse box.
3.
Please note that all wiring connections should be done by a qualified electrician.
4.
This unit is to be used in an AC220V / 50Hz supply zone only.
5.
Do not install in damp locations or immerse in water. (For indoor use only.)
6.
To avoid damaging the transmitter prevents dropping or banging the transmitter.
7.
Do not attempt to shorten the receiver's antenna wire.
8.
If the transmitter is not used for some time, please remove batteries to avoid leakage
that will damage the transmitter.
B. OPERATION INSTRUCTIONS:
1.
After installing the receiver, make sure the transmitter has its batteries installed.
2.
If the transmitter is not functioning properly or not function or if the fan is not moving
please do the followings:
a) Turn off the electrical mains at the circuit breaker/fuse box.
b) Follow steps on page 8-9 to reinstall the receiver.
C. FUNCTIONS OF TRANSMITTER:
HI
:
Set fan to high speed.
MED
:
Set fan to medium speed.
LOW
:
Set fan to low speed.
OFF
:
Turn off the ceiling fan.
Put the transmitter into transmitter cover.
OFF
H I
M E D
LOW
NOTE: THE TRANSMITTER IS DESIGNED FOR USE WITH EITHER WALL BRACKET
FOR TRANSMITTER (d.) OR THE TRANSMITTER COVER (b.)
Wall bracket for transmitter
(If desired, install onto the wall with screws.)
OFF
H I
M E D
LOW
Hide quick links:
Advertisement
Table of Contents
