Vento FINO Assembly And Installation Manual page 5

3. Put the downrod through the canopy opening, as shown in the diagram.
4. Insert wire and safety wire through the downrod set. Fit one end of the downrod, with no ball
attached, to the top portion of the "U" tube. Put the washer through the downrod screw. Then
put the washer and spring washer through the downrod screw at the other end. Then tighten
hex nut firmly and securely.
5. Loosen screws at the side of the center of blades, push the blade into the axle. Tighten the screws.
Ball
Canopy
Downrod
Spring Washer
Hex Nut
Washer
Flat Washer
Downrod Screw
Screw
Screw