Instructions - Vento Ventomist VTHPMF-3010 Manual

High Pressure Misting Fan 30"
A. Before Operation
1. Lock the casters to prevent the misting fan from accidentally moving.
2. Make sure the fan brake is released before moving.
3. Make sure the fan is connected secured securely to hhe unit and adjust the fan height.
4. Fasten the water hose to the inlet socket on the water tank.
5. Connect the nozzles to the misting ring tigjtly to prevent leaking.
6. Use only clean water and check that there is sufficient water in the tank.
7. Check that the power cable is connected to a power supply of the correct voltage and
frequency.
8. Set the running and stop times on the timer and adjust the fan angle and speed.
(For more information on setting the timer, please see Digital Timer Instructions,
Page 36.)
9. Constantly push the air release valve for 15 seconds when running the pump for the
fist time, when restarting the pump after it has run out of water, or after a long period
without use.
△ !
ATTENTION:
Make sure the length of the cable is longer than 10 meters and the diameter of extension
cords used is larger than 18AWG.
B. Filling the water tank
1. Donot fill water over the water float or the water might splash out and cause
malfunction.
2. Do not take the water filter away while filling the water to the tank.
3. Keep motor and electrical devices in dry conditions while adding the water to the
tank.
C. After Operation
1. Press OFF for 5 seconds to stop the misting pump.
2. Stop the fan and turn off the water supply.
3. Open the drain cap on the bottom to empty the tank.
www.ventomist.com
GENERAL INSTRUCTIONS
17
by
+1 (281) 724-8222
VTHPMF-3010
sales@ventomist.com