Texture Control; Feed Control Knob - NutriMill plus Owner's Manual

TEXTURE CONTROL

NOTE: The instructions below are a general rule, results will vary depending on the size of
the grain. The texture of your flour is managed by the flow rate of the grain and the motor
speed. The lower the motor speed and the more open the feed gate (the more grains going
in at a time), the coarser the flour will be.
• For most flour, motor speed switch should remain on "FINE" (up).
• For coarse flour and medium fine corn meal, the motor speed can be on "COARSE"
(down).
• Adjust for desired results based on your experience.
• The control knob is the ON-OFF switch and a gate that controls how quickly grains
can flow into the mill.
• For finer flour, set the knob to feed slowly (setting 1-2).
• For coarse flour, turn the knob toward the right to feed grain more quickly (setting 3).
• Large items (like beans) won't begin to flow until the knob is set to setting 3.
• Texture results also vary with the kind of grain being milled. Soft grains, such as oats,
mill much finer than hard grains. Hard wheat mills more coarsely than soft wheat.
• Larger items, such as legumes, will feed slowly while small grains, like amaranth or
millet, will flow into the mill quickly.

FEED CONTROL KNOB

Texture Control Knob
ON/OFF Knob
Fine/Coarse
Motor Speed Switch
Slowest grain
OFF
feed rate
1
FINE
COARSE
7
2
3
Fastest grain
feed rate