NEC MultiSync LCD1880SX Quick Start Manual page 10

Canadian Department of Communications Compliance Statement
DOC : This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
C-UL : Bears the C-UL Mark and is in compliance with Canadian Safety Regulations according to CAN/CSA
C22.2 No. 950.
FCC Information
1.Use the attached specified cables with the MultiSync
radio and television reception.
(1) Please use the supplied power cord or equivalent to ensure FCC compliance.
(2) Please use the specified shielded video signal cable, 15-pin mini D-SUB to 15-pin mini D-SUB cable,
15-pin mini D-SUB to DVI-I cable or DVI-D to DVI-D cable.
2.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy, and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult your dealer or an experienced radio/TV technician for help.
If necessary, the user should contact the dealer or an experienced radio/television technician for additional
suggestions. The user may find the following booklet, prepared by the Federal Communications Commis-
sion, helpful : "How to Identify and Resolve Radio-TV Interference Problems." This booklet is available from
the U.S. Government Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
U.S. Responsible Party: NEC-Mitsubishi Electronics Display of America, Inc.
Address :
Tel. No. :
Type of Product :
Equipment Classification : Class B Peripheral
Model :
Windows is a registered trademark of Microsoft Corporation. NEC is a registered trademark of NEC Corporation. E
is a U.S. registered trademark. All other brands and product names are trademarks or registered trademarks of their
S
TAR
respective owners.
As an E
S
NERGY TAR
guidelenes for energy efficiency. The E
E S
NERGY TAR
or service.
*
LCD1880SX_QS.P65
DECLARATION OF CONFORMITY
1250 North Arlington Heights Road, Suite 500
Itasca, Illinois 60143-1248
(630) 467-3000
Display Monitor
MultiSync LCD1880SX
We hereby declare that the equipment specified above
conforms to the technical standards as specified in the FCC Rules.
* Partner, NEC-Mitsubishi Electronics Display of America has determined that this product meets the
®
: Trademarks apply to appropriate countries.
10
® * LCD1880SX color monitor so as not to interfere with
emblem does not represent EPA endorsement of any product
S
NERGY TAR
English- 2
16/1/02, 12:09 pm
NERGY