Servicing Notes; General; Locating The Controls - Sony D-FJ200 Service Manual

NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK OR
BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic break-
down because of the potential difference generated by the charged elec-
trostatic load, etc. on clothing and the human body. During repair, pay
attention to electrostatic breakdown and also use the procedure in the
printed matter which is included in the repair parts.
The flexible board is easily damaged and should be handled with care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on the
disc reflective surface by the objective lens in the optical pick-up block.
Therefore, when checking the laser diode emission, observe from more
than 30cm away from the objective lens.
Before Replacing the Optical pick-up Block
Please be sure to check thoroughly the parameters as per the "Optical
pick-up Block Checking Procedure" (Part No. : 9-960-027-11) issued
separately before replacing the optical Pick-up block.
Note and specifications required to check are given below.
• FOK output : IC601 yg pin
When checking FOK, remove the lead wire to disc motor.
• RF signal P-to-P value : 0.4 to 0.8Vp-p

LOCATING THE CONTROLS

CD player (front)
1 ./>• TUNE –/+ • PRESET –/+
2 3 4 RADIO ON/BAND• MEMORY
5 u*
i (headphones) jack
A
*The button has a tactile dot.
CD player (inside)
SECTION 1

SERVICING NOTES

SECTION 2

GENERAL

OPEN
6 HOLD (rear )
B
Open the battery
compartment lid.
Laser Diode Checking Methods
During normal operation of the equipment, emission of the laser diode
is prohibited unless the upper panel is closed while turning ON the
S809(push switch type).
The following two checking methods for the laser diode are operable.
Method :
Emission of the laser diode is visually checked.
1. Open the upper lid.
2. Push the S809 as shown in Fig. 1 .
3. Check the object lens for confirming normal emission of the laser
diode. If not emitting, there is a trouble in the automatic power
control circuit or the optical pick-up. During normal operation, the
laser diode is turned ON about 2.5 seconds for focus searching.
S809
Fig.1 Method to push S809
7 DISPLAY/MENU
8 P MODE/
9 SOUND
Strap hole
q; qa x/CHG ADIO OFF
Display
DC IN 4.5 V (external power
input) jack
qs VOL +*/–
Insert the # end first (for both
batteries).
D-FJ200/FJ201
This section is extracted from
instruction manual.
3