Extech Instruments HD200 User Manual page 6

Setup Option Mode
Entering and Changing a Setup Options
1. Press and hold the Setup button for 3 seconds to enter the Setup mode.
"SETUP" will appear in the upper right-hand corner of the LCD
▲
2. Press or
3. Press ENTER to begin editing the selected option.
▲ ▼
4. Press or
5. Press ENTER to store the new setting in memory and step to the next option
6. Press and hold the Setup button for 3 seconds to exit the Setup mode
Display
T1
T2
T3
SLP
tiE
rAt
CLR
Note: Setup is disabled in MIN MAX/AVG or REC mode.
Offset (for T1, T2, or T3)
The primary display shows the actual temperature plus the offset; the secondary display shows only
the offset value. Individual offsets for T1, T2 and T3 can be stored for later recall.
Auto Power Off mode (SLP)
1. The default mode is Sleep Mode ON (the meter will automatically shut off after 20 minutes of
inactivity).
▲
2. Press or
3. Press ENTER to show the current setting (ON or OFF).
▲
4. Press or
(sleep mode on) or 0FF (sleep mode off).
Time Setting (tiE)
1. Display the time. The primary display shows the year. The secondary display shows the month
and the day, the third display shows the hours and minutes. Press ENTER to exit the time
setting option without making changes.
2. Set the time. The order is year--- month ----day---- hours--- minutes. Use °C·°F·°K to select a
digit group. Use the
setting in memory.
Sample Rate (rAt)
The third display shows the datalogger sample rate. The default sample rate is 1 second. The third
display show "0 0
and seconds. The flashing digits indicate the digits ready to be edited. Press
sample rate. Press ENTER to store the new setting in memory.
Erase the Datalogger Memory (CLR)
To clear the memory, enter the CLR setup mode, press
confirmation screen "SURE YES" and press ENTER to clear the memory.
▼
to scroll to the desired setup option
to change to the desired setting.
Option
T1 Offset
T2 Offset
T3 Offset
Sleep Mode
Time setting
Sample rate
Clear
▼
to scroll to the "SLP" page.
▼
to change the setting. Press ENTER to store the new setting in memory. On
▲ ▼
or buttons to change the setting. Press ENTER to store the new
0 1". The order is minutes/seconds. Press °C·°F·°K to toggle between minutes
Description
Adjust T! offset value
Adjust T2 offset value
Adjust T3 offset value
ON (mode on) or OFF (sleep mode off)
Check the time or Set the time
Set the datalogging sample interval
Clear the datalogger memory
▲ ▼
or
6
▲ ▼
or
until the display shows the
HD200-en-GB_V2.3 4/15
to change the