Set Id Setup; Power Saving; Hcec Setup - LG LW76 Series Installation Manual

26
INSTALLATION MENU

Set Id Setup

Set Id Lock
- Set the 'Set ID' item in 'GENERAL' Menu whether to activate or not.
- Set to Yes(Work) or No(Do Not Work).
Set Id
- Set the 'Set ID' of TV Set with 1~99.

Power Saving

Static Saving
- It is the item for setting the level to reduce the backlight control from the items for saving the
consuming power, which is increased or decreased by 10 steps from 0 to 100. 100 makes
the consuming power set to the same one from the TV. 0 reduces the consuming power to the
minimum. The default value is 100.
* The value displayed at the OSD is not changed and only the actual setting value is converted to
percentage based on the static saving value to set.
* 0 ~ 30: HIGH, 40 ~ 60 : MID , 70 ~ 90 : LOW , 100 : OFF
Keyless Off Hours
- Automatically TV will be turned off if there is no key input for the preset time period.
* Set the 'OFF', '1~99'.

HCEC Setup

CEC Mode
- Determines whether to use TVLink-CEC. The default value is No. When No is selected, you
cannot set subitems.
Ir decoding
- Determines whether to decode the LG remote control. If No is selected, the TV does not decode
it and sends signals only to the IR Out port. You need to run Forced Initialize below once to apply
it.
If Yes is selected, the TV decodes and changes it into a CEC Message and sends it to Command
via the HDMI CEC Line. The default value is No.
device Id
- Sets the ID of a device connected to the TVLink-CEC Line. You can choose between 1 and E.
The default value is E.
StandBy
- Set the CEC OpStandby command.